When you make a pinhole camera for roll or sheet film, use a small can or box as the camera body. You can use anything that has a tight-fitting top - a clean paint can, a vegetable shortening can, a 2-pound coffee can, a shoebox, or even a cylindrical oatmeal box.
To make the can light-tight, paint the inside with dull black paint or line it with black paper to prevent light reflections. If the can you use has a plastic lid, paint the lid black.
Be sure to paint it inside and out; then before using it, check to make sure no paint has chipped off. Chipped or peeling paint on the lid will allow light to enter the camera and ruin your pictures.
The film will be attached to the inside of the lid so you will need to make the pinhole in the bottom end of the can. You can make the actual pinhole in the can itself, but it's much easier to make it in a separate piece of heavy black paper or thin metal and fasten this piece over a larger hole cut in the center of the bottom end of the can. Heavy-duty aluminium foil, a piece of aluminium cut from a soda can or anything alike.This is a picture i have taken from a pin hole camera that i made, to the left is the origional image (negative) the one to the right is photshopped to give a better image.
The distance of the film from the pinhole and the diameter of the pinhole will determine the angle of view and sharpness of your final image. For a camera with the pinhole 3 to 6 inches from the film, you'll get the best results if the pinhole is about 1/75 inch in diameter. You can make a hole this size by pushing a No. 10 sewing needle through the paper or metal to a point halfway up the needle shank. The pinhole should as circular as possible.
You can load the camera either with film or fast photographic paper. Your choice of film or paper may depend in part on the exposure times.
Paper is easier to handle since you can load it into the camera under a safelight. If you don't have a safelight, you can work by the light of a flashlight covered with several thicknesses of red cellophane paper placed 6 to 8 feet away. Most film, on the other hand, must be handled in total darkness.
The f stop is the distance from the pinhole to the paper, example , 47mm ÷ 0.8 = 15 seconds




